5 Laws Everyone Working In Sliding Patio Doors Repair Should Know

· 6 min read
5 Laws Everyone Working In Sliding Patio Doors Repair Should Know

Sliding Patio Doors Repair

It is possible for sliding patio doors to be difficult to open and close. This could be due to various issues like dirty tracks or a misaligned slider.

Clean and lubricate your rollers. You can also adjust the rollers using adjustment holes on the bottom side of the door panel that can be moved.

Tracks that are damaged or dirty

A sliding door that does not slide properly can result from an unclean or damaged track. Over  www.repairmywindowsanddoors.co.uk , dirt, grit and even rust can build up blocking the track from moving smoothly. A gentle detergent and a brush will do the trick. It is recommended to complete this task regularly to ensure the smooth operation of your door, and to avoid the need for expensive repairs later on.

A leaky door can be a frequent issue. It requires immediate attention in order to prevent structural deterioration, water damage and the growth of mold. The most common cause is worn weather stripping and misaligned doors. These can be fixed by replacing old weather strips and aligning the door.

Another issue that is common and can be fixed with a little DIY work is when rollers jump off their track. This task can be difficult so you may need a helper to assist you. To reposition the rollers to the right position, sit inside the house and lean one of the panels toward you. To stop the panel from falling, place it on sawhorses after it has been lifted off the bottom track. Then loosen the screws that keep each roller in place, and take them off using a screwdriver. Now, you can get rid of any dirt that is stuck between the tracks and the wheel. Clean each wheel with denatured alcohol on a rag. Reposition the wheels back to their tracks and then attach them again.

If a portion of the track is bent, it may be possible to straighten it by using the help of a rubber mallet and a block of wood. If the bent section is close to hinges or has the potential to cause more damage, it's best to call in a professional.

Misaligned Rollers

If your sliding door isn't moving as it should, it's likely because the roller wheels are misaligned with the track. The wheels may be dirty, rusted, or their bearings have worn out. This creates friction between the floor of the door and the track, causing it to snag or grind when it's closed or opened. This can also result in noises that squeak.

This is a simple solution. You don't have to remove the door to get at the wheels, since they are mounted on a bracket that is adjustable. Locate the holes for adjustment (usually on the opposite side of the frame) and use a screwdriver to rotate the screws that control the wheels. A clockwise rotation of the screw raises the wheel while a counterclockwise turn lowers it. Continue adjusting the door until it opens and closes effortlessly.

It's important to adjust the wheels prior to adjusting the latch. The latch hooks must align with the strike plate (the opening through which the latch locks) in order for the lock to work correctly. If you don't do this, the latch could open or close when you're out of the room.

Sliding patio door are an investment. Maintaining them in good working order will keep your family safe. By addressing common problems like faulty tracks, rollers and handles, you can prevent expensive repairs in the future. Contact us for more information about patio doors. We can assess your needs for repair of your sliding patio door and help you keep it in top condition. Our experts can also assist with any replacement parts that you might require.

The door frame is sagging or damaged

Sliding patio doors make a fantastic addition to any home and offer an attractive and convenient alternative to hinged or swing-open patio door options. Like all hardware items sliding patio doors are prone to become problematic in time. Fortunately, many of these issues are simple to repair with a little DIY knowledge.

A gap in the frame is a frequent problem with sliding patio doors. It could be due to a variety of factors, including rollers or tracks that are not aligned properly, a damaged track or door, or a bent frame for the door. In the majority of cases, the cause of this issue is easily remedied by removing the door and re-attaching the track or rolling elements. This should be done with extreme care so as not to damage the frame or track.

In certain situations, it may be necessary to replace the entire track, which can be easily accomplished using an universal replacement kit that is available at all major hardware stores. These kits are simple to install and will have your door back to normal in a matter of minutes.

Examine your sliding door's hardware and frame for signs of wear, for example loose bolts or screws. These can often be tightened with a screwdriver or wrench and is a simple and efficient DIY patio door maintenance process. In addition, it is essential to grease your rollers and tracks to make sure they operate smoothly and avoid premature wear.


For many homeowners the patio doors are the primary entrance to their backyard and outdoor living space. Therefore, they have to be able to function properly in order to ensure the safety of their homes and provide security. By following these easy DIY maintenance tips, homeowners can prolong the life of their sliding patio door and cut down on costly repairs or replacements.

A faulty handle

Sliding patio doors provide the perfect way to access your backyard and also enter your home, but they aren't always easy to operate if they are damaged or misaligned. A damaged handle could cause the door to not shut or open properly. The good news is that fixing loose handles is a simple task that can be accomplished at home.

In most cases, a loose handle is the result of screws that have made through the backplate. To remedy the issue tighten the screws on the inside of the handle with a screwdriver. If the handle is still loose it could be an indication that the threads have worn out and need to be replaced.

Alternatively, a broken latch might be the culprit. It is more likely that the latch will break if made of metal, as opposed to plastic. If the latch isn't turning or catching you can try oiling it first to see if this aids. If this doesn't work, you may need to replace the lock.

The handle, in turn, could become difficult to use in the event that it is broken or damaged. If this is the case it is essential to replace it with a new handle that is in line with the design of your sliding patio door.

Feldco can help restore your patio doors to their former splendor, whether they're new or outdated. We have a variety of high-quality patio doors in different sizes and styles. Contact us today to find out more about our products! We provide homeowners with our services in Southern California, including Ventura County, Orange County & San Diego County.

Faulty weatherstripping

If you're seeing light in closed doors and windows or feel a draft pushing against the window or door It's time to replace your weather stripping. These strips create an airtight seal, which stops unwanted water, air and pests from getting into your home. This helps to keep your conditioned and heated air inside, saving money on energy bills.

Depending on the condition of your weather stripping it may have deflated and lost its buoyant positive seal. This can be identified by taking a dollar note and putting it through the seal on top of the door frame and at the bottom of the door jamb where the two meet. If the dollar bill slides effortlessly between the seal and the door then it's time to replace the weather stripping.

It's tempting to remove only the worn portion of weather stripping and replace it, but this can result in cracks on the sides of the new piece and could cause problems with the seal in the future. It is much more effective to replace all the stripping. This will allow you to be sure that your door will be properly sealed.

To make a DIY project that is simple follow our guide to weather stripping to remove old weather stripping and install the correct material on your sliding patio door and frame to ensure a long-lasting and secure seal. This is a great method to save money on your energy bills and fix your sliding patio door. Don't wait until its too late. You'll save money and enhance the appearance of your home.